Publish Time: 2022-01-18 Origin: Site
When using automatic plywood edge trimming machine, daily inspection work is very necessary and also a very important work. But how to check each part of the automatic plywood edge trimming machine? The inspection work can be carried out from the following points.
1. Turn on the power switch of the automatic plywood edge trimming machine. Set the temperature of the electric heating controller of the quad saw, mechanically turn on the electric heating switch, and turn on the oil pump switch of the quad saw.
2. The setting of the pressure index of the automatic plywood edge trimming machine (rotate the screw, move to the set pressure index value, rotate the screw, end the pressure setting, and close the box door. After pressing the power start button of the four-sided saw, the heating plate will automatically rise, automatically After holding the pressure to the set time value, the heating plate automatically descends.
3. After confirming that there is no error in the automatic plywood edge trimming machine, it is necessary to confirm the temperature, pressure, time of the hot pressing, and the model and specification of the hot pressing product.
4. Place the automatic plywood edge trimming machine hot-pressed product evenly on the aluminum plate of the high-temperature resistant cloth, then cover the product with a high-temperature resistant cloth, put it into the hot press layer of the hot press, and close the door of the hot press box.
5. Press the start button of the hydraulic cylinder of the automatic plywood edge trimming machine to start the hot-pressing action. After rising, start the set time. When the hot-pressing time is reached, it can automatically descend and take out the hot-pressed product.
The above is the inspection work of the automatic plywood edge trimming machine. So what problems will occur in the processing of the automatic sawing machine?
During the processing of the automatic plywood edge trimming machine, the template will break the glue when it is cut. What is going on?
First look at the board. If the bonding quality is not good, it will seriously affect the bonding ability of the board, and the saw end may be broken. Then, due to the operation of the equipment, if the cutting end of the sheet starts with the forming sheet of the hot pressing plate, the speed will be excessively pursued, and the cutting will start before the adhesive of the sheet is ready, and the sheet will be sizing. This can also happen if the drama knife does not break when cutting, or if the blade is chipped. In fact, most of the reasons are due to the quality of the plate. As long as the product quality meets the standard and the situation is dealt with in time, the problem can be solved.
The second is to pay attention to its quality when using a automatic plywood edge trimming machine. If we do not know how to distinguish its quality, it is best to buy products from big brands, because in this way, the quality of its products is guaranteed after sale. Of course, we should also pay attention to the correct operation and use, which can not only prolong its service life, but also improve the working efficiency of the automatic plywood edge trimming machine.